Unimark XP Manual do Utilizador descarregar pdf (Página 13)

Page 13 of 23

The Configuration Menu is accessed by pressing and holding the "Shift" button, then pressing the "SEL/Menu"

button.

Installing the Ribbon:

1. Open carriage compartment cover.

2. Slide the printhead contrast control lever toward the front of the printer.

3. Place the back of the ribbon on printhead assemble (as shown below).

4. Turn the ribbon advance knob clockwise while pressing down on the front of the ribbon. Turning the

advance knob will ensure the knob will align properly on the keyed drive shaft. The ribbon should snap

into place.

5. Adjust the darkest of the print by moving the contrast forward.

Select Paper Paths:

Select paper path and insert paper.

Tractor Feed Adjustment:

1. Adjust the left tractor feed to set the start of print. The lock is released when placed in the up position.

2. Adjust the right tractor feed to hold the paper tight.

Communications:

Connect Communication Cable (serial or Parallel but not both).

Connect Power & Set Configuration:

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 22 23

Sem comentários

Unimark XP Manual do Utilizador Página 13