
Page 6 of 23
2. Press: Command
3. Press: Menu
4. Press: Accept. NOTE: The defaulted printer config line will be printed.
Default Position D (Itin) - 11 inch Stock = 14; 28; 32; 41; 81; 84; 85; 9B
The correct settings for Windows 2000 and XP would be one of the below:
Serial = 14; 28; 32; 41; 81; 84; 97; 9B - (ITN) D/E dial position
Serial = 14; 28; 32; 41; 81; 84; 91; 92; 97; 9B (ATB) A dial Position
Parallel = 17; 28; 32; 41; 81; 84; 97; 9B - (ITN) D/E dial position
Since the default settings (as printed) are different from the proper settings, immediately above, changes to
the settings are necessary to be performed in steps 5-8 below.
Note
: Although the default is slightly different when used in position A as an ATB1 ticket printer, the same
changes noted below will still have to be done, for serial or parallel use.
In order to make the necessary changes follow the steps below:
5. Press Change: it will print COMM MODE = 14-ON. If this is a serial printer, skip the next
step and proceed with the directions. For a parallel printer complete the next step and
continue.
6. Parallel Printer ONLY) Press Change repeatedly until COMM MODE = 17-ON prints,
then press Accept.
7. (Serial & Parallel continued) Press Accept repeatedly until COMM MODE = 85-ON prints.
Now press Change, then press Accept.
8. Press Normal, then press Command, then Normal, then Command and then Normal. This
will permanently save the changes we have made.
Table 4. Configuration Codes & What They Control
Communication Mode
13-Full Duplex Modem
14-Serial Mode-Direct Connection-Pin 11 On For Ready
15-Serial Mode-Direct Connection-Pin 11 Off For Ready
16-Current Loop
17-Parallel Mode (Menu LED Illuminated)* This Is Only Valid for Itinerary Printers
18-Communications Controller Interface (if installed)
Baud Rate
21-110 BPS
22-200 BPS
23-300 BPS
25-1200 BPS
26-2400 BPS
27-4800 BPS
28-9600 BPS
2A-19200 BPS
Parity
31-7/1/Odd/No
32-7/1/Even/No
35-7/1/Odd/Yes
36-7/1/Even/Yes
37-7/1/Mark/No
38-7/1/Space/No
39-8/0/Not Used/No
3A-8/1/Odd/Yes
3B-8/1/Even/Yes
National Language Character Sets
41-United States
42-France
Comentários a estes Manuais