Page 16 of 23
Disable Auto LF (to prevent double spacing)
1. Press the On/Off Line Key to take the printer off line.
2. Press Park key to park paper.
3. Open the Keypad Door to enter Setup Mode.
4. Press the Feature (down arrow) until display reads Auto LF Enable.
5. Press the Value (up arrow) key to change the display to Auto LF Disabled.
6. Press the enter key to save the new value.
7. Close the Keypad Door to exit the Setup Mode. The LCD will read: Press "Profile" to Save Settings.
Press Profile key to save entry.
8. Press the Load key to load paper (resets top of form).
9. Press the On/Off Line key to place the printer back on line.
10. Load paper into the main tractors.
11. Press the Load key to load forms.
12. Press the On/Off Line key to go back on line.
13. Adjust Tear Off (see instruction below).
Alignment Instructions
Tear Off Adjustment
In a demand document application, the form will be advanced to a tear off position when a document is printed.
When the forms are in this position, the last printed form may be removed by pulling the perforation against the
tear edge of the cover.
If the perforation does not come to rest at the tear edge, the tear off distance may be adjusted as follows:
1. Press the "Tear Off" key. The form should move up to the current tear location.
2. Using the key "Up Arrow" and/or "Down Arrow" key, move the paper until the perforation is located at
the desired tear off position.
3. Press the "Tear Off" key. The form will return to the current print position.
4. This adjustment affects the tear distance feature and is automatically saved in memory for the current
profile and will be applied when forms are reloaded.
Run Self Test
1. Open the Keypad Door to access the Setup Menu.
2. Press the Feature (up arrow) key once. The LCD will show"Run Self Test".
3. Press the Enter key to start the self test. The display will alternate as follows:<Diagnostics> and "Enter"
to Stop.
4. To stop the self test, press the Enter key or close the Keypad door.
Print Profile Settings
1. Make certain 20 column or wider paper is loaded in the printer.
2. Press the On/Off Line key to take printer off line.
3. Before entering Setup Mode, press the Profile key until it displays the profile you wish to print.
4. Open the Keypad door and use the Next Menu key to go to Menu 9. The display will read: M9
Diagnostics
5. Press the Feature (down arrow) key until the display reads: <Print Profile>
6. Press the enter key. The printer will print a listing of the profile feature settings.
7. Close the Keypad Door to exit the Setup Mode.
8. Press the On/Off Line key to return to normal operation.
.
(9 páginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentários a estes Manuais